Logo holodilshchik
ПЕРВАЯ В РОССИИ ИНТЕРНЕТ-ГАЗЕТА ПО ХОЛОДИЛЬНОЙ И БЛИЗКОЙ ЕЙ ТЕМАТИКЕ
Свидетельство о регистрации СМИ Эл № ФС 77-20452 от 22 марта 2005 года

ООО 'АВИСАНКО' предлагает холодильные камеры любого объема под ваши требования...
Грамотно преподнести себя через рекламу - тоже искусство!
АННОТАЦИИ к статьям научно-теоретического журнала "ВЕСТНИК МАХ"

    


Выпуски по годам: [2011] [2010] [2009] [2008] [2007] [2006]

Обложка журнала 'Вестник МАХ'...

В настоящей рубрике публикуются аннотации к статьям «Вестника Международной академии холода» ("Вестника МАХ") - международного ежеквартального научно-теоретического журнала, являющегося печатным органом общественной организации - «Международной академии холода» ("International Academy of Refrigeration").

Вестник МАХ издается с 1998 года.

Главный редактор журнала: Бараненко Александр Владимирович, д-р техн. наук, профессор.

Тематика журнала: "Исследования и разработки по всем направлениям холодильной и криогенной техники, кондиционированию воздуха и проблемам экологии".

The international scientific-theoretical quarterly magazine about scientific and technical developments on all directions of refrigeration, cryogenic engineering and technology, air conditioning and problems of ecology.

«Vestnik of International Academy of Refrigeration» – published since 1998.
[1/2008]


Перечень статей и аннотаций по номерам выпусков: [1/2008] [2/2008] [3/2008] [4/2008]


 1.  Математическое описание рабочих процессов винтового компрессора на фазе регулирования производительности / А.В. АНУФРИЕВ, В.И. ПЕКАРЕВ (Санкт-Петербургский государственный университет низкотемпературных и пищевых технологий)

  • The change in the section area of a relief port of a screw compressor, the volumetric capacity of which is regulated by a slide valve, is considered. The standard slide valve and the slide valve with changed rims located under the angles, equal to the turning angles of the screw lines of the corresponding rotors are compared. The analysis of change of the relief port area by the turning angles of the driving rotor shows that if the valve with changed rims is used, then this area in the phase of control is always larger, i.e., the gas dynamic resistance is less. Besides, the mathematical model of the compressor BX-130 (R22) shows that compressor efficiency with the changed slide valve during capacity control is 2 - 8 % higher, than if the standard slide valve is used.

    Подробнее по подписке >>


 2.  Экспериментальное исследование растворимости хладагента R600a в компрессорном масле Reniso WF15A / Канд. техн. наук Ю.В. СЕМЕНЮК, С.В. НИЧЕНКО, д-р техн. наук В.П. ЖЕЛЕЗНЫЙ, В.В. СЕЧЕНЫХ (Одесская государственная академия холода)

  • The paper presents the results of experimental investigation of solubility of the refrigerant R-600a in mineral oil Reniso WF15A and the pressure of saturated vapor of the system R-600a/Reniso WF15A. The measurements are fulfilled by static methods in the temperature range 288 < T < 393 K and with pressures up to 29 bar. The obtained experimental data are approximated by small constant equations within the frame of model ideas about thermodynamic similarity of solutions refrigerant/oil. The temperature and concentration dependencies of pressure of saturated vapors of solutions R- 600a with the oil Reniso WF15A have been studied.

    Подробнее по подписке >>


 3.  Конструкции микротеплообменников криогенных систем для охлаждения маломощных электронных устройств / Д-р техн. наук А.М. АРХАРОВ, канд. техн. наук Е.В. ДИЛЕВСКАЯ, С.И. КАСЬКОВ, канд. техн. наук Ю.А. ШЕВИЧ (Московский государственный технический университет им. Н.Э. Баумана)

  • The designs of wound micro heat exchangers made from finned capillary tubes for throttle cryogenic systems, working at 4,5...80 K are considered. The advantages of heat exchangers, where the tube is wound on the core in one or several rows are presented. The versions of two-cascade and three- cascade designs of micro heat exchangers are given, and the characteristics of a helium three-cascade microliquefier are presented.

    Подробнее по подписке >>


 4.  Оптимизация геометрических параметров перекрестноточных пластинчатых рекуператоров / Н.В. БЕЛОНОГОВ, В.А. ПРОНИН (Санкт-Петербургский государственный университет низкотемпературных и пищевых технологий)

  • The method of optimization of crossflow plate recuperators is proposed. The optimization calculations are given for recuperators RKP1 -200, RKP1- 250 and RKP1-315 with the change of the height of the plate from 1 to 8,5 mm. Thermal efficiency of a recuperator, pressure drop of the removed air and the total area of plates of the heat exchange pack are chosen as the criteria of optimization. A global function of quality for the considered task is given, and on the basis of its analysis the optimum height of the plate is found. The method can be used for the optimization by the arbitrary number of independent values.

    Подробнее по подписке >>


 5.  Математическая модель течения неизотермического закрученного двухфазного потока внутри горизонтальной трубы / Д-р техн. наук В.Г. БУКИН, канд. техн. наук А.Ю. КУЗЬМИН, Ю.В. МИНЕЕВ (Астраханский государственный технический университет)

  • The method of mathematical simulation of flow of the two-phase twisted stream inside the horizontal pipe is offered. The present model also allows to determine obliquely heat transfer coefficient through magnitude of the part of wetted surface.

    Подробнее по подписке >>


 6.  Применение ЭГД-генератора - детандера в системах использования энергии сжатого природного газа / Д.В. БОРОДИН, Г.И. БУМАГИН, А.В. ЗИНОВЬЕВА (Омский государственный технический университет), Е.И. РОГАЛЬСКИЙ (ООО "Научно-технический комплекс "Криогенная техника", г. Омск)

  • In recent years interest to energy-saving technologies is increased, so more often the problem of compressed natural gas energy utilization is considered. One of more effective methods is expansion of compressed natural gas in effective work removal expanders. In this connection this paper presents an application of electro-gas-dynamic generator-expander (EGD G-E). Under support of Russian Basic Research Founda-tion, the subproducts of Omsk State Technical Universities activity are performed here. Some schemes of heat-recovery energy systems on basis of EGD G-E are reduced, the factors are described and estimated value of its basic specifications is made.

    Подробнее по подписке >>


 7.  Связь между упругими постоянным цилиндрически анизотропного тела / Канд. техн. наук В.Н. ГЛУХИХ (Санкт-Петербургский государственный университет низкотемпературных и пищевых технологий)

  • A task for the determination of stresses of cylindrically anisotropic body is considered. The relationship between the elasticity constants of such a body has been established. By mathematical transformations the number of constants for their experimental determination according to standard procedures has reduced from 18 to 9. The presence of the minimum on the curve of the elasticity module over X axis is proved.

    Подробнее по подписке >>


 8.  Потери при замораживании и холодильном хранении дикорастущих ягод / Д-р техн. наук С.В. ФРОЛОВ, канд. техн. наук В.В. ДАНИН, канд. техн. наук М.И. КРЕМЕНЕВСКАЯ (Санкт-Петербургский государственный университет низкотемпературных и пищевых технологий)

  • The method for calculation of possible weight loss during freezing and subsequent cold storage of wild-growing berries is presented. Evaporation resistance coefficients used in the calculations were determined experimentally for four kinds of berries.

    Подробнее по подписке >>


 9.  О выборе технологии криостатирования индивидуальной криосауны / А.Ю. БАРАНОВ, В.А. БАРАНОВ, В.М. ЛЕ КУАНГ (Санкт-Петербургский государственный университет низкотемпературных и пищевых технологий)

  • The quality of cryotherapeutic apparatuses is determined by the isotropy of a temperature field in the cabin of a cryo-sauna bath. A mathematical model of an individual cryotherapeutic plant, allowing evaluation of the working ability of different versions of cryostatting of the cabin, is considered. The flow- through and circulation schemes of the plant are compared. The latter reduces nitrogen consumption for the procedure almost 20-fold.

    Подробнее по подписке >>


 10.  Центры клеточных и генных технологий и современные банки стволовых клеток: криогенные предприятия, соответствующие GMP - стандартам / Д-р мед. наук А.Б. СМОЛЯНИНОВ, А.Н. ГРОМЫКО (Центр клеточной терапии, Покровский банк стволовых клеток, "КриоЦентр Санкт-Петербург"), д-р мед. наук Е.В. ЖАРОВ, канд. мед. наук Д.А. КИРИЛЛОВ (Институт восстановительной медицины, Москва), канд. техн. наук Ш.М. БАГАУТДИНОВ (Военно-медицинская академия, С-Петербург)

  • It is very important to develop GMP-standard stem cell banks in Russia, because of frequent popularity of different diseases and absence of registers of bone marrow and cord blood stem cells. Practical experience of work of centers of cell and gene therapy, stem cell banks have to take into account developing of technological base for new cell technologies in clinical practice.

    Подробнее по подписке >>


 11.  Перспективные разработки в области металловедения для криогенного и низкотемпературного оборудования / Ю.П.СОЛНЦЕВ (Санкт-Петербургский государственный университет низкотемпературных и пищевых технологий)

  • The paper reports in detail about the developments of the Chair of technology of metals and metal science of the SPb GUN and PT in the field of increasing of reliability and durability of cryogenic equipment. First of all, this is the creation of new marks of steel: maraging steels, metastable austenitic steels, and casting steels for low temperatures. The performance and advantages of new steels under operating conditions at low temperatures are presented. The other direction is an increase in reliability of equipment - the analysis of working ability of steels at low temperatures. For this purpose it is necessary to create new techniques of non-destructive control, one of which (for oil and gas lines) is proposed by the author.

    Подробнее по подписке >>







Приглашаем ученых и инженеров, аспирантов и студентов, а также,
заинтересованные институты, фирмы, организации и частных лиц, принять участие в размещении
информации в интернет-газете, посвященной холодильной и близкой ей тематике.

Учредитель  и издатель сетевого СМИ: Маргарян С.М.
Адрес редакции: Россия, г. Москва, Шипиловский проезд, д.47.
Тел.: +7-916-186-57-39, e-mail: info@holodilshchik.ru

Первый выпуск первой в России интернет-газеты по холодильной и
близкой ей тематике - "Холодильщик.RU" - вышел в свет в январе 2005 г.
Руководитель проекта и Главный редактор: Санасар Маргарян
За содержание рекламных материалов редакция ответственности не несет.
При перепечатке статей, ссылки на их авторов и интернет-газету обязательны.
Разместите на своем сайте нашу кнопку... Rambler's Top100 Многоязыковая поисковая система...





Авторские права © 2005-2020 // MARGARY@N

Партнеры: